DGSHAPE DWX-42W - Email Notification Settings; Receiving Milling Machine Status Notification Email

122
4. Useful Functions
Receiving Milling Machine Status Notication Email
You can use VPanel to congure the settings in order to receive email with notications of the following items�
• Milling nished
• An error has occurred�
• Maintenance nished
MEMO
When more than one machine is connected, all of the machines become the targets for the settings� You cannot select a specic
machine to target�
Procedure
A
Show VPanel.
" 
B
Select the machine to operate.
C
Click .
D
Click the [Mail] tab, and then select the [Use mail notication] check box.
This makes it possible to enter items such as the [Receiver address].
Email Notication Settings