Replacing Consumable Parts
Replacing the Spindle Unit
Replacement time
• Spindle working time: Over 1,500 hours (varies depending on usage conditions)
Remarks
• You can use VPanel to view the working time of the spindle� Refer to VPanel to determine when replacement is needed�
• The spindle unit is a part that wears out� Contact your authorized Roland DG Corporation dealer when it is time for replacement�
Replacing Milling Burs
Replacement time
• Work time: More than 7 hours
Remarks
• The milling bur work time can be viewed in VPanel�
"
• The milling bur is a consumable part� To purchase this part, contact your authorized DGSHAPE Corporation dealer or access
our website (http://www�dgshape�com/)�
Replacing Coolant Filters
CAUTION
Do not overll or tilt the coolant tank.
The uid inlet on the coolant tank is open. Overlling or tilting will cause uid to spill out.
CAUTION
When raising or lowering the coolant tank, hold the position indicated in the following gure.
Failing to do so may result in your ngers being pinched, leading to injury.
Replacement time
• When a coolant lter is dirty
• Every 20 hours (When the work time exceeds 20 hours,
changes to the display shown below�)
72
3. Maintenance
To Next Page
Loading...