DGSHAPE DWX-52DCi - Page 4

Contents
4
Chapter 3 Maintenance ........................................................................................... 57
Maintenance Precautions..............................................................................................................................................58
Maintenance Precautions .............................................................................................................................58
Daily Maintenance ........................................................................................................................................................... 59
Cleaning after Milling Finishes .................................................................................................................... 59
Cleaning the Milling Bur/Adapter .............................................................................................................. 61
Care and Storage of Detection Pin and Automatic Correction Jig .................................................61
Periodic Maintenance ..................................................................................................................................................... 62
Situations Requiring Maintenance ............................................................................................................62
Situations Requiring Part Replacement ................................................................................................... 62
Spindle Run-in (Warm-up) ............................................................................................................................63
Correcting the Milling Machine .................................................................................................................. 65
Retightening the Collet..................................................................................................................................71
Regulator Maintenance (Emptying the Drain) ......................................................................................74
Regulator Maintenance (Cleaning the Bowl) ......................................................................................... 75
Replacing the Cleaning Tool ........................................................................................................................77
Chapter 4 FAQ ......................................................................................................... 78
Machine Trouble ..............................................................................................................................................................79
Initial Operations Are Not Performed or Fail .......................................................................................... 79
The Operation Button Does Not Respond ..............................................................................................79
VPanel Does Not Recognize the Machine ............................................................................................... 79
Adapter IDs Cannot Be Read ........................................................................................................................ 80
No Data Is Being Output to the Machine, or the Machine Will Not
Operate Even Though Data Is Being Output ..........................................................................................80
The Computer Shuts Down When Connecting Multiple Machines ...............................................81
The Adapter in Adapter Stocker Number 6 Cannot Be Replaced ................................................... 81
The Spindle Does Not Rotate .......................................................................................................................81
The Ionizer Is Ineective (Milling Waste Collects around the Milling Area) ................................ 81
Compressed Air Does Not Come Out .......................................................................................................82
Automatic Correction Fails ...........................................................................................................................82
The Cleaning Tool Is Not Eective ..............................................................................................................83
Milling Quality Problems ............................................................................................................................................... 84
The Milled Surface Is Not Attractive ..........................................................................................................84
There Is a Line of Level Dierence in the Milling Results ...................................................................84
Chipping Occurs (Edges of Milling Products Become Chipped).....................................................84
A Hole Opens in the Milling Results .......................................................................................................... 86
The Dimensions of the Milling Results Do Not Match ........................................................................ 86
Installation Problems ......................................................................................................................................................87
Installing the Driver Separately ...................................................................................................................87
Installing the Software and the Electronic-format Manuals Separately ......................................89
Driver Installation Is Impossible ..................................................................................................................90
Uninstalling the Driver ...................................................................................................................................92
Uninstalling VPanel .........................................................................................................................................93
Responding to Error Messages ....................................................................................................................................94
"1000-****" The % limit switch was not found. ......................................................................................95
"1006-02**" The % axis position has been shifted. ..............................................................................95