Company names and product names are trademarks or registered trademarks of their respective holders.
Copyright © 2017-2018 DGSHAPE Corporation
http://www.dgshape.com/
Contents
5
"1017-0000" The front cover was opened. ..............................................................................................96
"1017-0001" The front cover or the magazine cover was opened. ................................................96
"101C-0000" The milling bur sensor was not found. ...........................................................................97
"101D-****" The % milling bur cannot be released. ............................................................................97
"101D-0010" The cleaning tool cannot be released. ...........................................................................98
"101E-****" The % milling bur might be broken. .................................................................................. 99
"101F-****" The % milling bur chucking has slipped out. .............................................................. 100
"1020/1021-****" The % milling bur is too long./The % milling bur is too short. .................. 100
"1022-****" The % milling bur was not found. .................................................................................... 101
"1022-0010" The cleaning tool was not found. .................................................................................. 101
"1023-0000 to 1028-0000" Milling data error. ..................................................................................... 102
"1029-0000" The spindle experienced an overload. ......................................................................... 103
"102A-0000" The spindle experienced overcurrent. ......................................................................... 103
"102B-0000" The spindle motor temperature is too high. ............................................................. 104
"102D-0000" The spindle can not be turned. ...................................................................................... 104
"102E-0000" The spindle has collided with the rotary axis unit. .................................................. 104
"102E-0001" The changer has collided with the adapter. ............................................................... 105
"1030-0000" The dust collector is not working. ................................................................................. 105
"103B-0000" The automatic correction is not yet nished. ............................................................ 106
"103D-0000" Milling data error. The milling bur cannot reach the milling position. ............ 106
"1047-****" The machine's internal memory cannot be accessed. ............................................. 107
"1049-****" The adapter with ID number % cannot be released. ................................................ 107
"104A-****" The adapter with ID number % could not be grasped. .......................................... 108
"104B-00**" The adapter with ID number % was not found. ........................................................ 108
"104C-0000" All stockers are full, so the adapter could not be returned. ................................. 109
"104D-00**" An adapter with the same ID was found. .................................................................... 109
"104E-****" The % limit switch was not found. ................................................................................... 109
"104F-02**" The % axis position has been shifted. ........................................................................... 110
"1050-****" The operation to read a barcode failed. ........................................................................ 110
"****-****" An unknown error occurred. ............................................................................................... 111
A machine that has the same ID has been connected. ................................................................... 111
The adapter to use during milling has not been set. ....................................................................... 111
To Next Page
Loading...
