C
When the window shown in the following gure appears, click [OK].
The spindle unit will move, which will open the collet.
D
When the window shown in the following gure appears, click [OK].
E
Retighten the collet.
1 Fit the wrench onto the collet.
2 Insert the detection pin into the collet.
If the detection pin cannot be inserted, repeat the operations in steps
B
to
D
.
CAUTION
Use the included wrench and keep the
detection pin inserted. If the detection
pin is not inserted, the collet may be
deformed, resulting in lower milling
accuracy.
Periodic Maintenance
72
Chapter 3 Maintenance
To Next Page
Loading...
