Dieci APOLLO MINI AGRI - Page 167

Equipment | 9
AXH1230‐UK ﴾ENG﴿ ‐ Apollo KM 167
9.6.7.4 Picking up a load from a high position
1. Makesurethattheforkspasseasilyundertheload.
2. Drive slowly and cautiously approaching the vehicle to the
loadplacingitperpendiculartothiswiththeforkshorizontal.
Ifnecessary,usetheinchingpedaltoapproachslowly.
3. Alwaysremembertokeepthedistancerequiredtoinsertthe
forksundertheload,betweenthestackandthemachine.
4. Extendtheboomfortheshortestpossiblelength.
5. Afterbringingtheforksundertheloadtobelifteduntilitisin
contactwiththeforkcarrierplate,pressthebrakepedaland
movethegearselectorinneutral.
6. Lift the load and tilt the fork carrier plate to the transport
position.
7. Ifpossiblelowertheloadwithoutmovingthevehicle.
8. Lift the boom to move the load away, then retract the
extensions and lower the boom to set the load in the
transportposition.
9. If not possible, move the vehiclebackward very slowly and
verycarefully,aftermovingtheloadawayproperlyretractthe
extensions and lower the boom to set the load in the
transportposition.
150529-1