Digi XBee 3 ZigBee - Page 12

Digi XBee® 3 Zigbee® RF Module
12
$S (SRP Salt) 210
$V, $W, $X, $Y commands (SRPSalt verifier) 211
Sleep commands 211
SM (Sleep Mode) 211
SP (Cyclic Sleep Period) 212
ST (Cyclic Sleep Wake Time) 212
SN (Number of Cycles Between ON_SLEEP) 212
SO (Sleep Options) 212
WH (Wake Host Delay) 213
PO (Polling Rate) 213
ET (End Device Timeout) 213
SI (Sleep Immediately) 214
I/O settings commands 214
D0 (DIO0/AD0/Commissioning Button Configuration) 214
D1 (AD1/DIO1/TH_SPI_ATTN Configuration) 215
D2 (DIO2/AD2/TH_SPI_CLK Configuration) 215
D3 (DIO3/AD3/TH_SPI_SSEL Configuration) 216
D4 (DIO4/TH_SPI_MOSI Configuration) 216
D5 (DIO5/Associate Configuration) 217
D8 (DIO8/DTR/SLP_RQ) 217
D9 (DIO9/ON_SLEEP) 218
P0 (DIO10/RSSI Configuration) 218
P1 (DIO11 Configuration) 219
P2 (DIO12/TH_SPI_MISO Configuration) 219
P5 (DIO15/SPI_MISO Configuration) 219
P6 (DIO16/SPI_MOSI Configuration) 220
P7 (DIO17/SPI_SSEL Configuration) 220
P8 (DIO18/SPI_CLK Configuration) 221
P9 (DIO19/SPI_ATTN Configuration) 221
PR (Pull-up/Down Resistor Enable) 222
PD (Pull Up/Down Direction) 223
M0 (PWM0 Duty Cycle) 223
M1 (PWM1 Duty Cycle) 223
LT (Associate LED Blink Time) 224
RP (RSSI PWM Timer) 224
I/O sampling commands 224
IR (I/O Sample Rate) 224
IC (Digital Change Detection) 225
AV (Analog Voltage Reference) 225
IS (Force Sample) 226
V+ (Supply Voltage Threshold) 226
Location commands 226
LX (Location X) 227
LY (Location Y) 227
LZ (Location Z) 227
Diagnostic commands 227
VR (Firmware Version) 227
VL (Version Long) 227
VH (Bootloader Version) 228
HV (Hardware Version) 228
%C (Hardware/Software Compatibility) 228
%P (Invoke Bootloader) 228
%V (Voltage Supply Monitoring) 229
EA (MAC ACK Failure Count) 229
TP (Temperature) 229