Digi XBee 3 ZigBee User Manual

Digi XBee® 3 Zigbee® RF Module
13
CK (Configuration Checksum) 229
FR (Software Reset) 230
Memory access commands 230
AC (Apply Changes) 230
WR (Write) 230
RE (Restore Defaults) 231
Custom default commands 231
%F (Set Custom Default) 231
!C (Clear Custom Defaults) 231
R1 (Restore Factory Defaults) 231
Secure Session commands 232
*S (Secure Session Salt) 232
*V, *W, *X, *Y (Secure Session Verifier) 232
SA (Secure Access) 232
API Operation
API serial exchanges 235
AT commands 235
Transmit and Receive RF data 236
Remote AT commands 236
Source routing 236
Device Registration 237
API frame format 237
API operation (AP parameter = 1) 237
API operation with escaped characters (AP parameter = 2) 237
Send ZDO commands with the API 240
Example 242
Send Zigbee cluster library (ZCL) commands with the API 243
Example 246
Send Public Profile Commands with the API 248
Frame specific data 248
Example 251
Frame descriptions
AT Command frame - 0x08 255
AT Command - Queue Parameter Value frame - 0x09 257
Transmit Request frame - 0x10 259
Explicit Addressing Command frame - 0x11 262
Remote AT Command Request frame - 0x17 265
Create Source Route - 0x21 268
Register Joining Device - 0x24 270
BLE Unlock API frame - 0x2C 274
Example sequence to perform AT Command XBee API frames over BLE 276
User Data Relay frame - 0x2D 277
Example use cases 278
Example 278
Secure Session Control frame - 0x2E 279
AT Command Response frame - 0x88 283
Modem Status frame - 0x8A 285
Transmit Status frame - 0x8B 287
TX Status frame - 0x89 288
Receive Packet frame - 0x90 290

Digi XBee 3 ZigBee Specifications

General

Brand	Digi
Model	XBee 3 ZigBee
Category	Control Unit
Language	English