Maintenance
Operating Instructions 581 - 01.0 - 05/2016 121
6 Maintenance
This section describes simple maintenance work that needs to be
carried out on a regular basis, in order to extend the service life
of the machine and achieve the desired seam quality.
Advanced maintenance work may only be carried out by qualified
specialists ( Service Instructions).
Maintenance interval
WARNING
Risk of injury from sharp parts!
Punctures and cutting possible.
Prior to any maintenance work, switch off the
mach
ine or set the machine to threading mode.
WARNING
Risk of injury from moving parts!
Crushing possible.
Prior to any maintenance work, switch off the
machine or set the machine to threading mode.
Work to be carried out Operating hours
8 40 160 500
Machine
Remove accumulations of fluff
Remove any lint in the area below the throat
plate
Check the oil level
Check and clean the toothed belt
Lubricate the cutting punch
To Next Page
Loading...
