Programming
Operating Instructions 581 - 01.0 - 05/201668
5.4.3 Inserting a buttonhole within a sequence
It is not possible to insert buttonholes individually into the sequence.
Note the current sequence programming and change the sequence
accordingly ( p. 58).
You can also switch off sequential mode.
5.4.4 Switching off sequential mode
If you want to use single buttonhole mode instead of sequential
mode, switch off sequential mode.
To switch off sequential mode:
1. Press the button.
2. Use the button to navigate to the field Se
quential number
( p. 52).
3. Press the button.
4. Use the button to select the sequential number 0.
5. Press the button.
Th
e sequential mode is switched off.
6. Press the button.
Th
e setting mode is ended. This will take you back to the
user level.
To Next Page
Loading...
