Programming
Operating Instructions 581 - 01.0 - 05/2016 51
5.2 User level
On the user level, the most important information for sewing
operation is displayed.
5.2.1 Basic operation
You can change the values at user level by pressing the corre-
sponding button on the control panel ( p. 16).
Depending on where the cursor is positioned, the values change
e
ither in 1-step or 10-step increments.
Depending on the setting in the sequ
ence menu, either sequential
mode or single buttonhole mode is available ( p. 58).
You can tell which mode is activated by the
fact that it is highlighted
in the topmost field of the display after switching on ( p. 49).
5.2.2 Single buttonhole mode
On the user level, you can select a buttonhole from 50 pre-programed
buttonholes.
Fig. 37: Single buttonhole mode
To select a pre-programmed buttonhole:
1. Using the button, navigate to the field Butto
nhole
number (3).
(1) - Buttonhole shape (2) - Values
(3) - Buttonhole number
To Next Page
Loading...
