Programming
Operating Instructions 581 - 01.0 - 05/2016 67
5.4.1 Deleting a buttonhole at the end of a sequence
To delete a buttonhole at the end of a sequence:
1. Use the buttons or to select the last but one line of
the programmed buttonhole sequence.
2. Press the button.
3. Use the buttons or to select the buttonhole program 0.
4. Confirm with the button.
Th
e selected buttonhole is deleted.
When you want to quit setting mode, press the button. This will
take you back to the user level.
5.4.2 Adding a buttonhole at the end of a sequence
To add a buttonhole at the end of a sequence:
1. Use the button to select the last li
ne of the programmed
buttonhole sequence.
2. Press the button.
3. Select the desired buttonhole program using the
buttons or .
4. Press the button.
When you want to quit setting mode, press the button. This will
take you back to the user level.
To Next Page
Loading...
