Programming
Operating Instructions 581 - 01.0 - 05/201684
5.9.6 Threading position
The subitem Threading position is used to set how the
machine is set up.
Parameters in the Threa
ding position subitem
To set the threading position:
1. Select ( p. 69) Machine
config in service mode.
2. Press the button.
3
. Press the button as often as required until Threading
position is highlighted on the display.
Fig. 53: Threading position
4. Press the button.
Sta
ndard appears on the display.
Icon Entry Meaning
Possible
value range
Preset value
Threading
pos.
• Standard =
Normal
insertion
• Longitudinal =
Later
al insertion
To Next Page
Loading...
