Setup
Operating Instructions 581 - 01.0 - 05/2016 145
7.12 Assembling the suction container
Fig. 92: Assembling the suction container
The cutting waste that occurs during sewing ends up in the suction
container.
To assemble the suctio
n container:
1. Disassemble components 4, 5, 6 and 7 of the suction container
in accord
ance with the figure.
2. Insert the blanking plug (8).
3. Screw the suction container into the pre-drilled holes below
th
e oil pan using the screws (7).
4. Tighten the foam (6) with the spring plate (5) again.
5. Tighten the container (4).
6. Connect the hose (3) to the suction container via the injector.
Cutting waste is extracted via the h
ose (3) into the container (4).
7. Screw the angle piece (1) onto the injector.
8. Connect the suction container with the pressure supply via
th
e hose (2).
(1) - Angle piece
(2) - Hose
(3) - Hose
(4) - Container
(5) - Spring plate
(6) - Foam
(7) - Screws
(8) - Blanking plug
To Next Page
Loading...
