Operation
Operating Instructions 581 - 01.0 - 05/2016 39
4.11 Swiveling the machine up and down
Swiveling up
You must swivel the machine up for a
variety of activities (e.g. to
thread the looper thread or the gimp thread).
Fig. 27: Swiveling the machine up
To swivel the machine upwards:
1. Pull out the locking bolt (1).
2. Raise the machine at the front.
3. Release the locking bolt (1) again and allow it to engage in a hole.
To do this, you may have to swivel the machine up and down a
little.
4. Do not let go of the machine until the locking bolt (1) has
eng
aged.
WARNING
Risk of injury from sharp parts!
Punctures possible.
Only swivel up the machine when the machine is
swi
tched off or in threading mode.
(1) - Locking bolt
To Next Page
Loading...
