Maintenance
Operating Instructions 581 - 01.0 - 05/2016 123
6.1 Cleaning
The machine must be cleaned of dust and thread remnants on a
daily basis. A clean machine provides protection from disturbances.
To clean the machine:
1. Clean the area of the looper, thread cutter, throat plate and
th
e sewing head of sewing dust, thread remnants and cutting
waste.
If a vacuum is available, it i
s recommended to vacuum the
sewing waste.
2. If required, empty the cutting waste from the suction container.
WARNING
Risk of injury from flyin
g particles!
Flying particles can enter the eyes, causing injury.
Wear safety goggles.
Hold the compressed air gun so that the particles
d
o not fly close to people.
Make sure no particles fly into the oil pan.
NOTICE
Property damage from soiling!
Lint and thread remnants can impair the operation of the
ma
chine.
Clean the machine as described.
NOTICE
Property damage from solvent-based cleaners!
Solvent-based cleaners will damage paintwork.
Use only solvent-free substances for cleaning.
To Next Page
Loading...
