Programming
Operating Instructions 581 - 01.0 - 05/201680
4. Press the button.
7 appears on the display.
5. Enter the desired value using the arrow buttons.
5.9.4 Cut. time
In the subitem Cut. time you can set the switch-on time of the
cutting block individually. As a result, the sewing material to be
worked on is cut cleanly and such that it is not unnecessarily long.
Parameters in the Cut. time sub
item
To set the switch-on time of the cutting block:
1. Select ( p. 69) Machine config in service mode.
2. Press the button.
3. Press the button as often as required until Cut. time
is highlighted on the display.
Icon Entry Meaning
Possible
value range
Preset value
Cut. time Switch-on time
of the cuttin
g
block in ms
70-300 90
To Next Page
Loading...
