DURKOPP ADLER 581 - Multiflex (581-321 and 581-341 Only)

Programming
Operating Instructions 581 - 01.0 - 05/201688
5.9.9 Multiflex (581-321 and 581-341 only)
The subitem Multiflex is used to set the integrated cutting
system.
Parameters in the Multi
flex subitem
Mono mode
• X-correction left buttonhole
• X-correction right buttonhole
• Y-correction for both buttonholes
Multi mode
• X-correction left buttonhole
• X-correction right buttonhole
• Y-correction for both buttonholes
• Block length
• Blade number for left blade
• Blade number for right blade
To set the cutting system:
1. Select ( p. 69) Machine
config in service mode.
2. Press the button.
3
. Press the button as often as required until Multiflex
is highlighted on the display.
Icon Entry Meaning
Possible
value range
Preset value
Multiflex • Mono
•Multi