DURKOPP ADLER 581 - Changing the Cutting Blocks and Blade; Subclass Without Multiflex

Maintenance
Operating Instructions 581 - 01.0 - 05/2016130
6.4 Changing the cutting blocks and blade
Depending on the area of application, you must change the cutting
blocks and blade after six months at the earliest. You can change
the cutting length by changing the cutting blocks. The method for
changing the cutting blocks and/or the blade differs depending on
the subclasses.
6.4.1 Subclass without multiflex
Changing the cutting block
Fig. 79: Changing the cutting block
To replace the cutting block:
1. Loosen the screw (1) (Allen key in
the accessory pack).
2. Pull the cutting block (2) forward and remove.
WARNING
Risk of injury from sharp parts!
Cutting injuries may be sustained.
Only change the cutting block or blade when the
machine is switched off.
(1) - Screw (2) - Cutting block
①
②