Operation
Operating Instructions 581 - 01.0 - 05/2016 27
Fig. 12: Threading the needle thread (4)
4.6 Threading the looper thread
The machine must be in the end position, i.e. the looper turret
should face forward with the loopers.
Step
1. Remove the clamping plates ( p. 37).
2. Swivel the machine up ( p. 39).
3. Thread the looper thread (1) using the long threading wire
(accessory p
ack) as shown in the figures.
(5) - Tension disk
(6) - Spring
(7) - Needle bar
WARNING
Risk of injury from sharp parts!
Punctures possible.
Thread the looper thread when the machine is
swi
tched off or in threading mode.
To Next Page
Loading...
