Programming
Operating Instructions 581 - 01.0 - 05/201664
5.4 Sequence programming
The sequences are programmed on the S level.
Important
Once you press the button, you can no longer sew!
To program a sequence:
1. Press the button.
Th
e setting mode for the individual sequences is started.
2. Use the button to navigate to the Sequ
ential number
field ( p. 52).
3. Press the button.
Th
e following appears on the display:
Gimp monitoring (only for additional equipment 581-141
and 581-341): Monitoring on/off, as to whether the gimp
thread is inserted.
Following buttonhole: Number of the buttonhole that
is
sewn directly after this buttonhole without opening the
clamps. This makes it possible to carry out double passes.
Speed: Revolutions per minute.
Value Description
To Next Page
Loading...
