Operation
Operating Instructions 581 - 01.0 - 05/2016 23
Deactivating threading mode
To deactivate the threading mode:
1. Press the button (1) again. The button must disengage.
Af
ter a short pause, the machine is ready to sew again.
The sewing process is continued from the point where
threading mode was activated.
4.4 Inserting/changing the needle
Fig. 7: Inserting/changing the needle (1)
To insert or change the needle:
1. Loosen the screw (1).
2. Pull the needle (2) from the needle bar.
WARNING
Risk of injury from sharp parts!
Punctures possible.
Only change the needle when the machine is
switched off.
(1) - Screw (2) - Needle
To Next Page
Loading...
