Setup
Operating Instructions 581 - 01.0 - 05/2016 153
7.15 Adjusting the material edge stops
Fig. 100: Adjusting the material edge stops
To enable you to work precisely with the sewing material, you can
adjust the position of the material edge stops.
To set the material edge stops:
1. Insert the sewing material until it comes into contact with the
material
edge stops (2) on the right and left sides.
2. Loosen the screws (1) on the right and left sides.
3. Set the sewing position by moving the material edge stops (2)
ba
ck and forth.
4. Re-tighten the screws (1).
WARNING
Risk of injury from sharp parts!
Punctures possible.
Only set the material edge stops when the
mach
ine is switched off.
(1) - Screws (2) - Material edge stops
To Next Page
Loading...
