DURKOPP ADLER 581 - Sew.lamp

Programming
Operating Instructions 581 - 01.0 - 05/201696
5.10.3 Sew.lamp
In the subitem Sew.lamp you can set the brightness of the sewing
lamp, if this additional equipment is installed.
Parameters in the Sew.l
amp subitem
To set the brightness of the sewing lamp:
1. Select ( p. 69) User co
nfig. in service mode.
2. Press the button.
 The following appears on the display:
Fig. 60: Sew.lamp
3. Press the button as often as required until Sew.lamp is
highlighted on the display.
4. Press the button.
 100 appears on the display.
Icon Entry Meaning
Possible
value range
Preset value
Sew.lamp •0 = Off
• 100 =
Maxi
mum
brightness
0-100 100