DURKOPP ADLER 581 - Cut Control; Spec.funct

Programming
Operating Instructions 581 - 01.0 - 05/2016 91
5.9.11 Cut control
The subitem Cut control is used to set the cutting monitoring.
Parameters in the Cut c
ontrol subitem
5.9.12 Spec.funct.
You can set the following special functions:
• Only open clamps in the loading position (1)
• Subsequent sewing pattern (2)
• Extended min or max limits (4)
• Open clamps together (8)
• Extra-long buttonholes (16)
Up to 31 combinations are possible here.
Icon Entry Meaning
Possible
value range
Preset value
Cut control
•0 = Off
•1 = On
0-1 1