Programming
Operating Instructions 581 - 01.0 - 05/2016 85
5. Press the button.
Parallel b/h appears on the display.
5.9.7 Operation mode
The subitem Operation mode is used to set the operating mode.
Parameters in the Opera
tion mode subitem
You can check buttonholes in sample mode.
To set the operating mode:
1. Select ( p. 69) Machine
config in service mode.
2. Press the button.
3
. Press the button as often as required until Operation
mode is highlighted on the display.
Icon Entry Meaning
Possible
value range
Preset value
Operation
mo
de
• Standard =
Normal sewing
• Sample =
Machine stop
s
before the
buttonhole is cut
• Ta
ndem =
Connection to
a 2
nd
machine
• Ind
exer =
Machine is
installed on an
indexer
To Next Page
Loading...
