DURKOPP ADLER 581 - ZZ Offset

Programming
Operating Instructions 581 - 01.0 - 05/201690
Blades and their shape
5.9.10 ZZ offset
The subitem ZZ offset is used to set the compensation for the
zigzag stitch offset.
Parameters in the ZZ of
fset subitem
Part number Blade number Shape
0580 332000 31 With eye 2.8 x 4.3 x 36 mm
0580 332010 21 With eye 2.1 x 3.2 x 36 mm
0580 332020 02 Middle cut without eye 8mm
0580 332030 33 Only eye 2.8 x 4.3 mm
0580 332040 23 Only eye 2.1 x 3.2 mm
0580 332050 01 Without eye 36 mm
0580 332060 32 Middle cut with eye 2.8 x 4.3 x 8 mm
0580 332070 22 Middle cut with eye 2.1 x 3.2 x 8 mm
0580 332100 82 Eyelet ∅ 1.0 mm
0580 332110 83 Eyelet ∅ 1.5 mm
0580 332120 84 Eyelet ∅ 2.0 mm
0580 332130 86 Eyelet ∅ 3.0 mm
0580 332140 88 Eyelet ∅ 4.0 mm
Icon Entry Meaning
Possible
value range
Preset value
ZZ offset Zigzag stitch
of
fset
0.8-1.6 1.3