Programming
Operating Instructions 581 - 01.0 - 05/201652
2. Press the button.
Th
e cursor flashes.
3. Select the desired buttonhole number using the
buttons or .
As a selection aid, the current bu
ttonhole shape (1) and the
most important corresponding values (2) are displayed.
4. Confirm the selection with the button.
5.2.3 Sequential mode
Depending on the setting, the machine will be in either automatic,
manual or light barrier mode ( p. 49). In sequential mode you
can switch between programmed buttonh
oles in the sequence at
any time, unless you are working in light barrier mode.
There are 2 steps for selecting a buttonhole in sequential mode:
Order
1. Select a sequential number.
2. Select a buttonhole.
Fig. 38: Sequential mode
(1) - Buttonhole shape
(2) - Values
(3) - Sequence
(4) - Sequential number
To Next Page
Loading...
