Programming
Operating Instructions 581 - 01.0 - 05/201686
Fig. 54: Operation mode
4. Press the button.
Sta
ndard appears on the display.
5. Press the button as often as re
quired until the desired
value appears.
5.9.8 Tension data
In the subitem Tension data you can set the characteristic
values for the magnets of the needle thread tension.
Important
Only change the characteristic values when you install a new mag-
net! The corresponding values will be enclosed with the magnet in
a new
order.
To set the tension data:
1. Select ( p. 69) Machine
config in service mode.
2. Press the button.
Th
e following appears on the display:
To Next Page
Loading...
