Setup
Operating Instructions 581 - 01.0 - 05/2016 141
7.8 Setting the working height
Fig. 89: Setting the working height
The working height can be continuously adjusted between 73 cm
and 90 cm (measured to the upper edge of the tabletop).
To set the working height:
1. Loosen the screws (1) on both sides of the stand.
2. Adjust the tabletop of the machine
so that it is level at the
desired working height.
To avoid jamming, slide the tabletop in or out evenly at both
sides
.
3. Tighten the screws (1).
(1) - Screws
To Next Page
Loading...
