Programming
Operating Instructions 581 - 01.0 - 05/201656
5.2.6 Setting the cutting mode
On the display, the field (1) indicates the cutting mode. The cutting
mode determines when and whether a buttonhole is to be cut during
the sewing process.
For cutting mode, you can switch between the following parameters:
Parameters for cutting mode
Fig. 41: Setting cutting mode in sequential mode
To set the cutting mode:
1. Use the button to navigate to the field Cu
tting mode (1).
2. Press the button.
The cursor flashes.
Parameter Function
0 = No cutting
CA = Cut after the seam end (Cut After)
CB = Cut before the seam beginning (Cut Before)
(1) - Cutting mode
To Next Page
Loading...
