Programming
Operating Instructions 581 - 01.0 - 05/201666
Fig. 44: Programming sequences
6. Use the buttons or to select the position desired for
the buttonhole within the sequence (1
st
column of the display).
Th
e cursor shows the current position.
7. Press the button.
8. Use the buttons or to select the desired buttonhole
number (2
nd
column of the display).
Th
e buttonhole shape is displayed.
9. Press the button.
10. Use the buttons or to set the desired number of but-
tonholes (3
rd
column of the display).
11. Confirm with the button.
You can add further buttonhole programs. Start again with step 1.
(4) - Cutting length
(5) - Zigzag stitch adjustment
(6) - Cutting mode
(7) - Stitch length
To Next Page
Loading...
