Programming
Operating Instructions 581 - 01.0 - 05/201650
Manual operation
In the sequence shown on the display, lines are displayed between
the
buttonhole shapes. It is possible to see the currently selected
buttonhole from the bar below the number.
Fig. 35: Display for manual operation
The control does not change automatically between the buttonhole
shapes. Changes are made manually using the buttons
or .
Light barrier mode
If the light barrier kit is installed, it is p
ossible to work in light barrier
mode.
Either the lapel or the front edge is detected by 2 lig
ht barriers,
and the corresponding program is automatically selected.
Precisely 2 programs must be
entered in the sequence.
Light barrier mode can be recognized by the symbol (1).
Fig. 36: Light barrier mode
(1) - Symbol
To Next Page
Loading...
