Maintenance
Operating Instructions 581 - 01.0 - 05/2016 133
Information
If you want to use a cutting block with a different length, you must
make the appropriate setting on the control panel ( Service
Instructions).
Changing the blade
Fig. 82: Changing the blade (multiflex)
To change the blade:
1. Loosen screw (5) or (6) (Allen key in the accessory pack).
2. Remove blade (4) or (7).
3. Insert the new blade and tighten with screw (5) or (6).
Important
If you cannot remove the blade, slightly loosen the screw of the
se
cond blade.
(4) - Blade
(5) - Screw
(6) - Screw
(7) - Blade
To Next Page
Loading...
