Setup
Operating Instructions 581 - 01.0 - 05/2016150
2. Soak the wicks (1) and (2) as well as felt (5) with a little oil.
3. Add 1-2 drops of oil to the pendulum sleeve and needle bar (3).
4. Screw the head and side covers on.
5. Remove the clamping plates.
6. Soak the wick (4) with a little oil.
Fig. 97: Lubricating (3)
7. Add 1-2 drops of oil to the spreader plate (6) and to the
spreader (7).
Topping off the oil
For topping off the oil reservoir, use on
ly lubricating oil DA 10 or
oil of equivalent quality with the following specifications:
• Viscosity at 40 °C:10 mm
2
/s
• Flash point: 150 °C
(6) - Spreader plate (7) - Spreader
To Next Page
Loading...
