Troubleshooting
Operating Instructions 581 - 01.0 - 05/2016170
8251
–
8258
Fault during ADSP
boo
ting or booting
• Internal error
•Disturbance
• Switch the machine off and
on again
• Perform software update
• Contact Customer Service
9000
–
9004
Seam appearance
fau
lt
• Internal error • Switch the machine off and
on again
• Perform software update
• Reset the data ( Service
Instructions)
• Contact Customer Service
9009 Cutting punch is not in
position
• Cutting position sensor • Check the plug and cable
an
d replace, if required
• Replace the distributor board
Error Meaning Possible cause Remedial action
To Next Page
