DURKOPP ADLER 581 - Page 4

Table of Contents
2 Operating Instructions 581 - 01.0 - 05/2016
5.2.6 Setting the cutting mode......................................................................56
5.2.7 Resetting the piece counter.................................................................57
5.3 Buttonhole programming .....................................................................58
5.4 Sequence programming ......................................................................64
5.4.1 Deleting a buttonhole at the end of a sequence..................................67
5.4.2 Adding a buttonhole at the end of a sequence....................................67
5.4.3 Inserting a buttonhole within a sequence............................................68
5.4.4 Switching off sequential mode.............................................................68
5.5 Service mode ......................................................................................69
5.6 Activating the technician level .............................................................69
5.7 Buttonhole cycle..................................................................................71
5.8 Menu structure ....................................................................................72
5.9 Menu item Machine config ...........................................................75
5.9.1 Load. pos.............................................................................................75
5.9.2 Zigzag stitch width...............................................................................77
5.9.3 Thread mon.........................................................................................79
5.9.4 Cut. time..............................................................................................80
5.9.5 E-group................................................................................................81
5.9.6 Threading position...............................................................................84
5.9.7 Operation mode...................................................................................85
5.9.8 Tension data........................................................................................86
5.9.9 Multiflex (581-321 and 581-341 only)..................................................88
5.9.10 ZZ offset ..............................................................................................90
5.9.11 Cut control...........................................................................................91
5.9.12 Spec.funct. ..........................................................................................91
5.10 Menu item User config. ................................................................92
5.10.1 Language ............................................................................................92
5.10.2 Buttons ................................................................................................94
5.10.3 Sew.lamp.............................................................................................96
5.10.4 Key tones ............................................................................................97
5.11 Menu item Test functions ...........................................................98
5.11.1 Multitest...............................................................................................98
5.11.2 Sewing proc.......................................................................................106
5.11.3 Events ...............................................................................................113
5.12 Menu item Data transfer ............................................................116
5.12.1 Import ................................................................................................116
5.12.2 Export................................................................................................117
5.13 Menu item Reset data ..................................................................119
6 Maintenance.....................................................................................121
6.1 Cleaning ............................................................................................123
6.2 Lubricating.........................................................................................124
6.3 Servicing the pneumatic system........................................................127
6.3.1 Setting the operating pressure ..........................................................127
6.3.2 Draining the water condensation.......................................................127