MAINTENANCE, SERVICE AND FAULT FINDING
4-44 25364 Issue 8 March 2018
1024 Transfer failed Retry operation. If problem persists,
contact service technician.
1025 Not ready to transfer Contact service technician.
1026 Ribbon Warning The remaining ribbon has reached the
limit specified in the Error/Warning
screen. On the same screen the event
is set to cause an error.
Check the Error/Warning screen.
Check the remaining ribbon.
1040 Setting out of range The setting is out of range. Set to
correct range
1041 Undefined Error Reserved
1042 Unknown Error Reserved
1043 Design Pointer Not
Set
Reserved
1044 Design Delete
Timeout
Reserved
1045 Label Size Too Big The label is too large. Edit the design
and reduce the label size.
1046 No Text Defined Yet Reserved
1047 Upgrade Failed Upgrade failed.
Check the Software Versions screen.
1048 Special Action Not
Found:
Error in firmware/software. Contact
supplier and supply information on
how the error occurred.
1049 CRC Error All files on the controller have a CRC
checksum. The CRC checksum does
not match.
Either the file has been modified by an
unauthorised person, or the file is
damaged. Contact supplier.
1051 Error incompatible
version
Only on non-21CFR_Part 11
controllers:
The design being loaded is too new
(and hence the controller does not
know how to handle it).
Upgrade the controller to a newer
version.
Error No. Error Text Action
To Next Page
Loading...
