Ecotech Acoem Serinus 30 - Page 207

Appendix
Page 207
47
Diagnostic Test Pot
The Diagnostic mode adjustment pot for all the analysers
except for S30
48
NOx Input Pot
PMT signal input gain control FOR NOx
49
PGA Gain
1, 2, 4, 8, 16, 32, 64, 128
50
Gas 1 Inst.
Primary gas concentration currently displayed on the front
screen E.g. NO
51
Gas 2 Inst.
Secondary gas concentration currently displayed on front
screen E.g. NOx
52
Gas 3 Inst.
Calculated gas concentration currently displayed on front
screen E.g. NO2
53
Gas 1 Avg.
Average of the readings (for Gas1) of the last n minutes where
n is the averaging period
54
Gas 2 Avg.
Average of the readings (for Gas2) of the last n minutes where
n is the averaging period
55
Gas 3 Avg.
Average of the readings (for Gas3) of the last n minutes where
n is the averaging period
56
Instrument Gain
Current calibration value (default is 1.0)
57
Serial ID
Multidrop or Bayern-Hessen gas id
58
Bayern-Hessen ID
For multigas instruments only
59
Decimal Places
2 - 5
60
Noise
Instrument noise
61
Gas 1 Offset
An offset applied to Gas 1
62
Gas 3 Offset
An offset applied to Gas 3
63
Flow Temperature
Temperature of the flow block
64
Lamp Current
Lamp current in mA E.g 35mA
65
+5V Supply
Digital Supply voltage (should always read close to 5 volts)
66
Conc. Voltage
Concentration Voltage
67
High Voltage
High Voltage reading for PMT
68
Ozonator
0 = OFF, 1 = ON
69
Control Loop
0 = OFF, 1 = ON (default is ON)
70
Diagnostic Mode
0 = Operate
1 = Preamp
2 = Electrical
3 = Optical
(default is Operate)
71
Gas Flow
Units in slpm
72
Gas Pressure
Units in torr
73
Ambient Pressure
Units in torr
74
+12V Supply
The 12 volt Power supply voltage