Ecotech Acoem Serinus 30 - Page 208

Serinus® 30 User Manual 3.3
Page 208
75
Cell Temperature
Cell Temperature
76
Conv. Temperature
Converter Temperature
77
Chassis Temperature
Chassis Temperature
78
Manifold Temp.
Manifold Temperature
79
Cooler Temperature
Cooler Temperature
80
Mirror Temperature
Mirror Temperature
81
Lamp Temperature
Lamp Temperature
82
O3 Gen. Lamp Temp.
O3 Lamp Temperature
83
Instrument Status
Each bit in this 4-byte word represents a different condition
(not all conditions apply to every instrument model):
BIT
Condition if set
0
Currently in warmup process
1
Volumetric units (ppm); otherwise gravimetric units
(mg/m3)
2
Performing a background
3
Currently in Span mode
4
Currently in Zero mode
5
Instrument Out of Service (or in Diagnostic mode,
PTF compensation or control loop disabled, or
Comms debugging enabled)
6
High Voltage failure
7
System power failure (not actually possible to
report)
8
Reference voltage failure
9
Cell temperature failure
10
Cooler failure
11
Converter failure
12
Correlation wheel failure
13
Lamp source failure
14
Flow fault
15
Any system error (the red instrument panel light is
ON)
84
Reference Voltage
Units in Volts
85
Calibration State
This variable has two different sets of values:
Set Calibration State
0 = MEASURE
1 = CYCLE
2 = ZERO
Get IEEE Value
0 = MEASURE
1 = ZERO
2 = SPAN