C
HAPTER
31
| Loopback Detection Commands
– 1049 –
COMMAND MODE
Global Configuration
COMMAND USAGE
Refer to the loopback-detection recover-time command for information on
conditions which constitute loopback recovery.
EXAMPLE
Console(config)#loopback-detection trap both
Console(config)#
loopback-detection
release
This command releases all interfaces currently shut down by the loopback
detection feature.
SYNTAX
loopback-detection release
COMMAND MODE
Privileged Exec
EXAMPLE
Console#loopback-detection release
Console(config)#
show
loopback-detection
This command shows loopback detection configuration settings for the
switch or for a specified interface.
SYNTAX
show loopback-detection [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
COMMAND MODE
Privileged Exec
EXAMPLE
Console#show loopback-detection
Loopback Detection Global Information
Global Status : Enabled
Transmit Interval : 10
Recover Time : 60
Action : Shutdown
To Next Page
Loading...
