Edge-Core ECS3510-52T

C HAPTER 38 | Multicast Filtering Commands
IGMP Snooping
– 1210 –
EXAMPLE
The following shows the current IGMP snooping configuration:
Console#show ip igmp snooping
IGMP Snooping : Enabled
Router Port Expire Time : 300 s
Router Alert Check : Disabled
Router Port Mode : Forward
TCN Flood : Disabled
TCN Query Solicit : Disabled
Unregistered Data Flood : Disabled
802.1p Forwarding Priority : Disabled
Unsolicited Report Interval : 400 s
Version Exclusive : Disabled
Version : 2
Proxy Reporting : Disabled
Querier : Disabled
VLAN 1:
--------
IGMP Snooping : Enabled
IGMP Snooping Running Status : Inactive
Version : Using global Version (2)
Version Exclusive : Using global status (Disabled)
Immediate Leave : Disabled
Last Member Query Interval : 10 (unit: 1/10s)
Last Member Query Count : 2
General Query Suppression : Disabled
Query Interval : 125
Query Response Interval : 100 (unit: 1/10s)
Proxy Query Address : 0.0.0.0
Proxy Reporting : Using global status (Disabled)
Multicast Router Discovery : Disabled
VLAN Static Group Port
---- --------------- --------
1 224.1.1.1 Eth 1/ 1
.
.
.
show ip igmp
snooping group
This command shows known multicast group, source, and host port
mappings for the specified VLAN interface, or for all interfaces if none is
specified.
SYNTAX
show ip igmp snooping group [host-ip-addr ip-address interface |
igmpsnp | sort-by-port | user | vlan vlan-id [user | igmpsnp]]
ip-address - IP address for multicast group
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-16)
igmpsnp - Display only entries learned through IGMP snooping.