C
HAPTER
38
| Multicast Filtering Commands
MLD Snooping
– 1230 –
DEFAULT SETTING
10 seconds
COMMAND MODE
Global Configuration
COMMAND USAGE
This command controls how long the host has to respond to an MLD Query
message before the switch deletes the group if it is the last member.
EXAMPLE
Console(config)#ipv6 mld snooping query-max-response-time seconds 15
Console(config)#
ipv6 mld snooping
robustness
This command configures the MLD Snooping robustness variable. Use the
no form to restore the default value.
SYNTAX
ipv6 mld snooping robustness value
no ipv6 mld snooping robustness
value - The number of the robustness variable. (Range: 2-10)
DEFAULT SETTING
2
COMMAND MODE
Global Configuration
COMMAND USAGE
A port will be removed from the receiver list for a multicast service when
no MLD reports are detected in response to a number of MLD queries. The
robustness variable sets the number of queries on ports for which there is
no report.
EXAMPLE
Console(config)#ipv6 mld snooping robustness 2
Console(config)#
To Next Page
Loading...
Need help?
General
