C
HAPTER
38
| Multicast Filtering Commands
MVR for IPv6
– 1270 –
EXAMPLE
The following an MVR6 group address profile to domain 1:
Console(config)#mvr6 domain 1 associated-profile rd
Console(config)#
mvr6 domain This command enables Multicast VLAN Registration (MVR) for a specific
domain. Use the no form of this command to disable MVR for a domain.
SYNTAX
[no] mvr6 domain domain-id
domain-id - An independent multicast domain. (Range: 1-5)
DEFAULT SETTING
Disabled
COMMAND MODE
Global Configuration
COMMAND USAGE
When MVR6 is enabled on a domain, any multicast data associated with an
MVR6 group is sent from all designated source ports, to all receiver ports
that have registered to receive data from that multicast group.
EXAMPLE
The following example enables MVR6 for domain 1:
Console(config)#mvr6 domain 1
Console(config)#
mvr6 profile This command maps a range of MVR group addresses to a profile. Use the
no form of this command to remove the profile.
SYNTAX
mvr6 profile profile-name start-ip-address end-ip-address
profile-name - The name of a profile containing one or more MVR
group addresses. (Range: 1-21 characters)
start-ip-address - Starting IPv6 address for an MVR multicast
group. This parameter must be a full IPv6 address including the
network prefix and host address bits.
end-ip-address - Ending IPv6 address for an MVR multicast group.
This parameter must be a full IPv6 address including the network
prefix and host address bits.
To Next Page
Loading...
Need help?
General
