C
HAPTER
39
| LLDP Commands
– 1291 –
time of a notification are included in the transmission. An SNMP agent
should therefore periodically check the value of
lldpStatsRemTableLastChangeTime to detect any lldpRemTablesChange
notification-events missed due to throttling or transmission loss.
EXAMPLE
Console(config)#lldp notification-interval 30
Console(config)#
lldp refresh-interval This command configures the periodic transmit interval for LLDP
advertisements. Use the no form to restore the default setting.
SYNTAX
lldp refresh-interval seconds
no lldp refresh-delay
seconds - Specifies the periodic interval at which LLDP
advertisements are sent. (Range: 5 - 32768 seconds)
DEFAULT SETTING
30 seconds
COMMAND MODE
Global Configuration
EXAMPLE
Console(config)#lldp refresh-interval 60
Console(config)#
lldp reinit-delay This command configures the delay before attempting to re-initialize after
LLDP ports are disabled or the link goes down. Use the no form to restore
the default setting.
SYNTAX
lldp reinit-delay seconds
no lldp reinit-delay
seconds - Specifies the delay before attempting to re-initialize LLDP.
(Range: 1 - 10 seconds)
DEFAULT SETTING
2 seconds
COMMAND MODE
Global Configuration
To Next Page
Loading...
Need help?
General
