C
ONTENTS
– 13 –
Configuring Transceiver Thresholds 167
Performing Cable Diagnostics 170
Trunk Configuration 172
Configuring a Static Trunk 173
Configuring a Dynamic Trunk 175
Displaying LACP Port Counters 181
Displaying LACP Settings and Status for the Local Side 182
Displaying LACP Settings and Status for the Remote Side 184
Configuring Load Balancing 185
Saving Power 187
Traffic Segmentation 189
Enabling Traffic Segmentation 189
Configuring Uplink and Downlink Ports 190
VLAN Trunking 192
6 VLAN CONFIGURATION 195
IEEE 802.1Q VLANs 195
Configuring VLAN Groups 198
Adding Static Members to VLANs 200
Configuring Dynamic VLAN Registration 205
IEEE 802.1Q Tunneling 208
Enabling QinQ Tunneling on the Switch 212
Creating CVLAN to SPVLAN Mapping Entries 213
Adding an Interface to a QinQ Tunnel 215
Protocol VLANs 216
Configuring Protocol VLAN Groups 217
Mapping Protocol Groups to Interfaces 218
Configuring IP Subnet VLANs 220
Configuring MAC-based VLANs 222
Configuring VLAN Mirroring 224
7ADDRESS TABLE SETTINGS 227
Configuring MAC Address Learning 227
Setting Static Addresses 229
Changing the Aging Time 230
Displaying the Dynamic Address Table 231
Clearing the Dynamic Address Table 232
Configuring MAC Address Mirroring 233
To Next Page
Loading...
Need help?
General
