C
HAPTER
14
| Basic Administration Protocols
Simple Network Management Protocol
– 469 –
4. Fill in the IP address of a configured trap manager and the filter profile
name.
5. Click Apply
Figure 264: Creating SNMP Notification Logs
To show configured SNMP notification logs:
1. Click Administration, SNMP.
2. Select Configure Notify Filter from the Step list.
3. Select Show from the Action list.
Figure 265: Showing SNMP Notification Logs
SHOWING
SNMP STATISTICS
Use the Administration > SNMP (Show Statistics) page to show counters
for SNMP input and output protocol data units.
CLI REFERENCES
â—† "show snmp" on page 775
PARAMETERS
The following counters are displayed:
◆ SNMP packets input – The total number of messages delivered to the
SNMP entity from the transport service.
◆ Bad SNMP version errors – The total number of SNMP messages
which were delivered to the SNMP entity and were for an unsupported
SNMP version.
To Next Page
Loading...
Need help?
General
