C
HAPTER
14
| Basic Administration Protocols
Ethernet Ring Protection Switching
– 511 –
c. An ring node with a local manual switch command that
receives an R-APS message or a local request of higher
priority than R-APS (MS) clear its manual switch request.
The ring node then processes the new higher priority
request.
â–
Recovery for manual switching under revertive and non-
revertive mode is described under the Revertive parameter.
â–
Clear – Manually clears the protection state which has been
invoked by a forced switch or manual switch command, and the
node is operating under non-revertive mode; or before the WTR or
WTB timer expires when the node is operating in revertive mode.
â–
Two steps are required to make a ring operating in non-revertive
mode return to Idle state from forced switch or manual switch
state:
1. Issue a Clear command to remove the forced switch
command on the node where a local forced switch command
is active.
2. Issue a Clear command on the RPL owner node to trigger the
reversion.
â–
The Clear command will also stop the WTR and WTB delay
timers and reset their values.
â–
More detailed information about using this command for non-
revertive mode is included under the Revertive parameter. (See
the Command Usage section under "ERPS Ring Configuration"
on page 492.)
WEB INTERFACE
To block a ring port:
1. Click Administration, ERPS.
2. Select Configure Domain from the Step list.
3. Select Configure Operation from the Action list.
4. Select the domain name from the drop-down list.
5. Specify a Forced Switch, Manual Switch, or Clear operation.
6. Click Apply.
To Next Page
Loading...
Need help?
General
