C
HAPTER
18
| Using the Command Line Interface
CLI Command Groups
– 687 –
Interface Configures the connection parameters for all Ethernet
ports, aggregated links, and VLANs
967
Link Aggregation Statically groups multiple ports into a single logical trunk;
configures Link Aggregation Control Protocol for port
trunks
995
Mirror Port Mirrors data to another port for analysis without affecting
the data passing through or the performance of the
monitored port
1009
Congestion Control Sets the input/output rate limits, traffic storm thresholds,
and thresholds for broadcast and multicast storms which
can be used to trigger configured rate limits or to shut
down a port.
1019
Loopback Detection Detects general loopback conditions caused by hardware
problems or faulty protocol settings
1045
UniDirectional Link
Detection
Detect and disables unidirectional links 1039
Address Table Configures the address table for filtering specified
addresses, displays current entries, clears the table, or
sets the aging time
1051
Spanning Tree Configures Spanning Tree settings for the switch 1057
ERPS Configures Ethernet Ring Protection Switching for
increased availability of Ethernet rings commonly used in
service provider networks
1085
VLANs Configures VLAN settings, and defines port membership
for VLAN groups; also enables or configures private
VLANs, protocol VLANs, voice VLANs, and QinQ tunneling
1117
Class of Service Sets port priority for untagged frames, selects strict
priority or weighted round robin, relative weight for each
priority queue, also sets priority for DSCP
1159
Quality of Service Configures Differentiated Services 1173
Multicast Filtering Configures IGMP multicast filtering, query, profile, and
proxy parameters; specifies ports attached to a multicast
router; also configures multicast VLAN registration, and
IPv6 MLD snooping
1191
Link Layer Discovery
Protocol
Configures LLDP settings to enable information discovery
about neighbor devices
1287
Connectivity Fault
Management
Configures connectivity monitoring using continuity
check messages, fault verification through loopback
messages, and fault isolation by examining end-to-end
connections between Provider Edge devices or between
Customer Edge devices
1311
OAM Configures Operations, Administration and Maintenance
remote management tools required to monitor and
maintain the links to subscriber CPEs
1353
Domain Name Service Configures DNS services. 1365
Dynamic Host
Configuration Protocol
Configures DHCP client and relay functions 1375
IP Interface Configures IP address for the switch interfaces; also
configures ARP parameters and ND Snooping
1387
Debug Displays debugging information for all key functions
These commands are not described in this manual.
Please refer to the prompt messages included in the CLI interface.
Table 44: Command Group Index (Continued)
Command Group Description Page
To Next Page
Loading...
Need help?
General
