C
HAPTER
23
| Authentication Commands
802.1X Port Authentication
– 841 –
General Commands
dot1x default This command sets all configurable dot1x global and port settings to their
default values.
COMMAND MODE
Global Configuration
EXAMPLE
Console(config)#dot1x default
Console(config)#
dot1x port-control Sets dot1x mode for a port interface IC
dot1x re-authentication Enables re-authentication for all ports IC
dot1x timeout quiet-period Sets the time that a switch port waits after the Max
Request Count has been exceeded before attempting
to acquire a new client
IC
dot1x timeout
re-authperiod
Sets the time period after which a connected client
must be re-authenticated
IC
dot1x timeout supp-timeout Sets the interval for a supplicant to respond IC
dot1x timeout tx-period Sets the time period during an authentication session
that the switch waits before re-transmitting an EAP
packet
IC
dot1x re-authenticate Forces re-authentication on specific ports PE
Supplicant Commands
dot1x identity profile Configures dot1x supplicant user name and password GC
dot1x max-start Sets the maximum number of times that a port
supplicant will send an EAP start frame to the client
IC
dot1x pae supplicant Enables dot1x supplicant mode on an interface IC
dot1x timeout auth-period Sets the time that a supplicant port waits for a
response from the authenticator
IC
dot1x timeout held-period Sets the time a port waits after the maximum start
count has been exceeded before attempting to find
another authenticator
IC
dot1x timeout start-period Sets the time that a supplicant port waits before
resending an EAPOL start frame to the authenticator
IC
Display Information Commands
show dot1x Shows all dot1x related information PE
Table 81: 802.1X Port Authentication Commands (Continued)
Command Function Mode
To Next Page
Loading...
Need help?
General
